Thermal Stripper X-17

It used for heat stripping ribbon cable.

Technical Specification

<1> Charging setting:

1. When the stripper is power off and connect to the adapter, the stripper sounds “beeps”, the battery indicator flashes from L to H, and stays at the actual battery indicator, and the lower gear flashes.

2. When the power is turned on and the adapter is connected, the machine will beep.

3. When the battery power is too low, a beep will sound every 10 seconds, and the first gear will flash twice.

<2> ON/OFF setting:

1. Press and hold the "Power/Mode "button for 1 second, the stripper is turned on, a beep will sound, and the "HEATER Mode" indicator will light up.The "TEMP indicator" stays in the fourth gear, and the stripper starts to heat to the preset heating value.

2. Press and hold the "Power/Mode "button for 1 second again, the stripper will turn off with a beep sound; it will shut down automatically after 4 minutes of inactivity.

<3>Mode Setting：

1. Press "Power/Mode "button to switch modes when the stripper is power on.